![]() |
Westport Generating Station | | | Trudge | ![]() |
|
|||
Please remember that the comments posted here are not the opinions of opacity.us or its affiliates.
Comments pertaining to real location names, methods of entering the property, promotions or advertisements, off-topic discussion and general flaming, as well as those submitted under various aliases are subject to immediate deletion and your ip address being banned from this website. By submitting your comment you agree to these terms. Visit the forum for off-topic and general discussion. To prevent your comment from being removed and to help keep this site uncluttered, please read more about comments on opacity.
Memories and stories from past employees, visitors or patients are gratefully welcomed, they help keep these places alive!
![]() |
Westport Generating Station | | | Trudge | ![]() |
this round thing is called the rotor, the rotor is attached on the turbine
and so making the electicity that we need.
It is a very fine example of craftmanship.
I,ve seen these things working with a ancient steamengine in
Germany, .
But in modern powerplants they are the same today.
In every car that drives around is such a thing,
Apart from that, when you look to the middle of the upper three
windings you can see a black hole , that is a explosion due to a
short circuit, you can see the molten copper lying on the rotor, the
black partickles on the edge,
Forgive my English, i am from Holland, and i wish all of you a good
Christmas and a healthy 2011.
No need to apologize for your English, it's probably better then mine.. and English is my native language.
I noticed the black hole in the winding and the slag on the rotor, but wasn't sure what caused it. After looking at it a little closer, I think you are correct. That could have been the main reason the plant was permanently shut down. Rebuilding a generator like that would require it to be removed and shipped to a special facility. The cost of the repair plus the loss of income could have been the deciding factor to close the plant.